C000065L008A APAC OPTO C000065L008A -Single Mode Optical SFP Interface

DESCRIPTION

The transceiver consists of an optical subassembly housing the transmitter and receiver and an electrical subassembly. All are packaged together with a top metal cover and bottom shield. The optical subassembly consists of two parts. The transmitter side has a high-performance 1310 nm Fabry-Perot laser with backfacet monitor. The receiver side has an InGaAs PIN and a preamplifier.

The digital diagnostic monitoring (DDM) interface uses the same two-wire serial ID interface defined in the SFP MSA specification. The standard serial ID information is located at address A0h. Using address A2h the user can monitor transceiver parameters including temperature voltage laser bias current laser power and receiver power. Alarms and warnings are provided when the monitored parameters exceed predefined threshold values. The transceiver includes a loss-of-signal-detect circuit which provides a TTL logic high output when an unusable input optical signal level is detected.

The transceiver is a hot-pluggable duplex- LC transceiver designed for use in Fibre Channel applications up to 4.25 Gbps without rate select. The multi-rate feature enables it use in a wider range of system applications. It is compliant with FC-PI-2 400-SM-LC-M 200-SM-LC-L and 100-SM-LC-L. The rate select pin (pin 7) has no effect on module performance. These transceivers provide the LC optical receptacle that is compatible with the industry standard LC connector.
 

2024-02-23 11:55:23

Page: 5