NUDO-14-FJG SYSCOM TOWERS Forged Steel Clamp Cable Clip for 1/4" Hot-Dip Galvanized Steel Cable.

Highlighted Features:

• Made of forged steel.
• Hot-dip galvanized coating.
• Recommended maximum torque: 35 N.m.
• Recommended for use with 1/4" retention (SRET635CAM or SRET14DA).
• Recommended for use with three pieces of clamping.
• Ideal for heavy loads.
• Recommended for suspension or fixation of guyed towers masts poles and similar structures.

Safety Notes:

• Use the same size clip for the same size steel cable.
• Never use malleable iron clips in critical heavy-duty or suspended load applications such as slings suspension lines guidelines drag lines load fixation scaffolding etc.
• Malleable iron clips are for terminations only:
• Only for light-duty and non-critical applications such as light loads handrails lattice area protection etc.
• Apply an initial load to check the assembly. This load should be equal to or greater than the weight it will support. Then check and retighten the nuts to the recommended torque.

Method for installing the clamps:

1. Run the cable the necessary length around the cable clamp and install the first clip at a distance equal to its bases width from the cables extreme tip. Tighten the nuts alternately to the specified torque.
2. When only two clips are required install the second clip as close as possible to the bend of the cable or cable clamp and tighten the nuts alternately to the specified torque. When more than two clips are required install the second clip as close as possible to the bend of the cable or cable clamp and turn the nuts firmly without tightening.
3. Install all necessary clips between the first two with equal spacing and in the same position. Ensure all clips nuts are tightened according to the specified torque.
4. Finally apply a load equal to or greater than expected to test the assembly. Then check and retighten the nuts according to the recommended torque with the help of a torque wrench.

2023-11-29 15:55:33

Page: 8