- New
- Out Of Stock - info [email protected]
LDF250FT
ALTAI TECHNOLOGIES C1AN Super Wi-Fi CPE / Access Point Long Range 5.1-5.8 GHz with Integrated Antenna
WIRELESS INTERFACE
802.11a/n (2x2) Radio
Operating Mode: AP/ CPE/ Bridge/ Repeater
Standard: IEEE 802.11a/n
Operating Frequency: 5.15 – 5.35 GHz
5.47 – 5.725 GHz
5.725 – 5.825 GHz
Transmit Power: 29 dBm (Max.)
26 dBm (Per Chain)
Receiver Sensitivity
802.11a 54 Mbps -83 dBm
6 Mbps -96 dBm
802.11n HT20 -95 dBm
HT40 -91 dBm
16 SSID (Max.)
WDS
Altai AirFi™ Throughput Optimization
Automatic Channel Selection (with Scheduling)
WMM
Preferred AP Association
ANTENNA (OPTIONAL ACCESSORIES)
Built-in 5 GHz Antenna 14 dBi Dual Slant ±45°Patch
Horizontal Beamwidth 35 - 45°(-3 dB)
Vertical Beamwidth 15 - 20°(-3 dB)
Front-to-back Ratio -20 dB (Max.)
NETWORKING
VLAN
IPv4/ IPv6 Dual-stack
Switch (Bridge) and Gateway Mode
DHCP Client/ Server/ Relay
NAT
PPPoE Client/ PPPoE Pass-through
VPN Pass-through
Bandwidth Control Per VAP/ Client
Multicast Rate Filter/ IGMP Snooping
Port Forwarding
SECURITY
Authentication – Open system Shared key WPA/ WPA-PSK WPA2/ WPA2-PSK 802.1x (EAP-PEAP/ TLS/ TTLS/ SIM/ AKA)
Encryption – WEP TKIP AES
RADIUS Client (PAP CHAP)
RADIUS Accounting Inter/ Intra-client Isolation
MAC-based Access Control (White/ Black List)
SSID Suppression WAPI
MANAGEMENT
Standalone (Managed by AWMS)
Thin AP/ CAPWAP Protocol (Managed by Access Controller)
Web User Interface
Command Line Interface (SSH)
3-level User Login
Remote Firmware Upgrade (HTTP TFTP)
SNMP v1/ v2c
MIB2/ IF-MIB/ Altai Enterprise MIB
Performance Statistics/ Alarm Information Display
WiFi Client Association/ Disassociation Statistics
Syslog
PHISICAL SPECIFICATIONS
Dimensions: 11 x 3.14 x 1 in (280 x 80 x 27 mm)
(excluding mounting)
Weight 0.4 kg
Mounting Desktop Pole Wall or Window-mounted
Network Interface 10/100 Mbps Ethernet Port
LED Display: Main Power Status
Ethernet Status
8-level Signal Strength
(User configurable)
POWER SUPPLY
Power Source PoE Injector (18V)
Power Consumption 6 W (Typical) / 8 W (Max.)
ENVIROMENTAL SPECIFICATIONS
Operating Temperature: -20 °C to 55 °C
Storage Temperature: -40 °C to 80 °C
Humidity: 5 – 95% (Non-condensing)
Wind Loading: Up to 200 km/h (124 mph)
Weatherproof Outdoor: UV Stabilized Plastic
IP55 Compliant
NOTE
The coverage range will be varied depending on NLOS and interference conditions. The transmit power may be varied according to country regulation. Although Altai has attempted to provide accurate information in these materials Altai assumes no legal liability for the accuracy and completeness of the information. All specifications are subject to change without notice.
HIGHLIGHTS
- Patented signal processing for improved radio performance in LOS and NLOS conditions
- Supports multiple isolated end-users through per client/VAP bandwidth control
- Per-end-user remote web-based management and client association status
- Optional high-performance external omni or sector antennas – optimizing performance when operating in conjunction with Altai A8/A8n series antennas.
- Operates both as a CPE and as a small WiFi access point for local coverage
- Integrated 8-level LED alignment mechanism for fast simple and best performing installation
- Weatherproof case (IP55 compliant) for enabling out-of-the-box outdoor installation
- The C1xn operates in the 2.4GHz band. The C1xan operates in the 5GHz band.
Designed as an essential component in the Altai Super WiFi system to extend outdoor WiFi coverage into indoor areas for broadband connectivity in 5 GHz band or use as an AP for pico coverage.
Complementing Altai’s super WiFi base station coverage solution are the C1xn/C1xan high-performance CPEs which employ a patented smart-signal processing algorithm and an antenna designed to increase WiFi signal strength.
2024-10-22 13:25:37
Page: 4
C1AN ALTAI TECHNOLOGIES Super Wi-Fi CPE / Access Point Long Range 5.1-5.8 GHz with Integrated Antenna C1AN
Reviews
No customer reviews for the moment.