MAXIMAL-3RH ALTRONIX Access Power Controller with Power Supply/Charger 8 Fused Relay Outputs 12/24VDC 6A 115VAC 2U

Maximal3RH rack mount access power controller distributes and switches power to access control systems and accessories. It converts a 115VAC 50/60Hz input into eight (8) independently controlled 12VDC or 24VDC fuse protected outputs. Outputs are activated by a normally open (NO) or normally closed (NC) dry trigger input from an Access Control System Card Reader Keypad Push Button PIR etc. This unit will route power to a variety of access control hardware devices including Mag Locks Electric Strikes Magnetic Door Holders etc. Outputs will operate in both Fail-Safe and/or Fail-Secure modes. The FACP Interface enables Emergency Egress Alarm Monitoring or may be used to trigger other auxiliary devices. The fire alarm disconnect feature is individually selectable for any or all of the outputs.

Input

• 115VAC 60Hz. 1.9A.
• Normally closed NC or normally open NO dry contact inputs (switch selectable).

Outputs

• 12VDC or 24VDC 6A total output current.
• Eight (8) fuse protected outputs.
• Maximum current per ACM8R-M output is 2.5A.
• Individually selectable Mag Lock/Strike (Fail-Safe Fail-Secure) solid state fuse protected outputs.
• Thermal and short circuit protection with auto reset.

Visual Indicators

• Individual Output Status LEDs located on the front panel.

Battery Backup

• Built-in charger for sealed lead acid or gel type batteries (if batteries are required install separate enclosure).
• Automatic switch over to stand-by battery when AC fails.
• Zero voltage drop when unit switches over to battery backup (AC failure condition).

2024-02-23 11:55:35

Page: 8